Drawmer MX60 Pro Front End One - Manual (Page 9)

CONTROL DESCRIPTION
INPUT PRE-AMP STAGE
The preamplifier section is based around Drawmer's own discrete component
mic preamp similar to that use in the well respected 1960, which provides very
low distortion and a wide dynamic range with an equivalent input noise
performance of !134dB.
Source Selection
Mic and Instrument buttons are provided along with status
LEDs for the direct selection of mic and line sources. When
both buttons are out, the Line input is selected as indicated
by the amber Line status LED.
______________________________________________________________
Mic See Source Selection
48V Switches on the phantom power if Mic source is selected.
______________________________________________________________
Line See Source Selection
______________________________________________________________
Instrument See Source Selection
+20dB Introduces +20dB of gain in the Instrument section.
Bright Provides a fixed amount of HF boost designed to
approximate the voicing of instrument amplifiers.
______________________________________________________________
Gain Adjusts the mic gain over a range of 60dB. Adjusts the
line/instrument gain over a range of !30dB to +30dB.
2Rev Inverts the phase of the signal leaving the preamplifier.
100Hz H.P. High-pass filter. Rolls off the low end to compensate for
microphone proximity effect.
9