Dynaflite GPMA0090 Butterfly - Manual (Page 31)

31
❏
11. Use the methods described previously to
cover the rest of the model in the correct covering
sequence.
Join the Tail Surfaces
Join the Stab, Fin and Fuse
❏
1. Apply a fi lm of 30-minute epoxy to the stab
and fuselage where they contact each other,
then position the stab on the fuselage. Use the
techniques described earlier (in
Align The Stab )
to confi rm that the stab is aligned with the fuselage,
then use T-pins, weights or clamps to hold the stab
to the fuse until the epoxy
fully cures. Use a cloth
dampened with alcohol to wipe away excess epoxy
before it cures.
❏
2. Glue the fi n to the stab and fuse. Use a
90-degree triangle or a square to hold the fi n
perpendicular, then hold it in position with T-pins or
masking tape until the glue fully cures. If you require
a little working time to align the fi n use 30-minute
epoxy. Otherwise you may use 6-minute epoxy.
❏
3. Test fi t the fi n reinforcements to the fi n and
stab. Take the reinforcements off the model, then
apply a bead of thick or medium CA to both “sides”
of one of the reinforcements. Immediately place the
fi n reinforcement on the fi n and stab and securely
hold it in position until the CA cures. Glue the other
reinforcement in position the same way.