EVCO EVD120 - Manual (Page 17)

17 EVD120
Programming
2.7 Reading the configuration parameters of EVD120 from the programming key
EVKEY
Operate as follows:
• make sure to have the programming key EVKEY
• switch off the power supply of EVD120
• connect EVKEY to port 2 of EVD120
• switch on the power supply of EVD120 and wait 4 s at least since the power supply has been switched on: LED Prog
of EVD120 will flash and the LED of EVKEY will shed green light
• press the button of EVKEY 4 s: the configuration parameters of EVKEY will be copied in EVD120; during the copy
the LED of EVKEY sheds red light (10)
• wait the LED of EVKEY finishes shedding red light (9)
• switch off the power supply of EVD120
• disconnect EVKEY from port 2 of EVD120.
(10) the copy of the configuration
parameters in EVD120 is only al-
lowed if the firmwares of the instru-
ments coincide; if they do not coin-
cide, LED Power/Status and Prog of
EVD120 will flash and the LED of
EVKEY will shed red light.