Fieldmann FZN 4001-A - Manual (Page 11)

EN
CORDLESS GRASS SHEAR & HEDGE TRIMMER USER'S MANUAL
10 Putting into operation
3 place the charger and battery in a location where the temperature is in the range of approximately
18 - 24 °C.
4 if problems with charging persist, have the charger and tool repaired at an authorised service
centre or the vendor.
The battery should be charged as soon as it stops delivering suffi cient power for work which was
performed easily with a fully charged battery. DO NOT CONTINUE using the tool in these conditions.
Follow the provided procedure for charging.
Under certain conditions with the charger connected to the mains the exposed charging contacts
inside the charger may be short circuited by foreign objects. No conductive materials such as steel
wool, aluminium foil or other metal items may enter the charger opening. Always disconnect the
charger from the mains power socket if there is no battery located in the charger. Before cleaning the
charger always disconnect it from the mains power socket.
Do no submerge the charger in water or any other liquid.
WARNING: Take care that no liquid enters the charger. This could cause an injury by electrical
shock. If you want to make it easier for the battery to cool down after being used with the tool, do
not place the charger or the tool in warm places such as metal buildings or open trailers.
Turning on the machine
ATTENTION: Press or release the start switch carefully according to the manufacturer's instructions.
Turn on the charged machine using the On/Off switch (pic. 1, no. 5). Operation will be shown on the
LED display (pic. 1, no. 1). Turn off the machine by releasing the switch, the chuck will stop turning.
Changing the blades (see pic. 12-14)
ATTENTION: Do not use the start switch before attaching or removing the blades. Risk of injury!
The blades can be changed easily and quickly without the use of other tools.
1. If you wish to change the blades, you must fi rst remove cover (A). Follow the steps shown in the illustration above.
Hold the tool using one hand as shown on the illustration above. Slide out the clip (B) with your
thumb and index fi nger of your other hand upwards.
Firmly hold the cover and pull it backwards.
Remove the cover in the upward direction.
2. Remove the blades and attach new blades.
ATTENTION: Do not use the start switch before attaching the blade covers. Risk of injury!
1. To attach the cover follow the steps shown on the illustration below.
1 Attach the blade cover so that the two marks are aligned as shown in the top illustration.
2 Push the blade cover forwards until it is secured by the clips in the correct position.
Important safety instructions for chargers
Read all instructions and warnings located on the charger, battery and tool before using the charger.
DANGER: The charger clamps have 230V. Do not probe with conductive items. Danger of serious
or fatal injury by electrical shock.