Fieldmann FZN 4001-A - Manual (Page 9)

EN
CORDLESS GRASS SHEAR & HEDGE TRIMMER USER'S MANUAL
8 Assembly of the machine | Putting into operation
Attaching and removing the wheel assembly (see pic. 2)
Slide on the wheel frame on to the projection on the handle and tighten the fastening bolt.
To remove the wheel assembly loosen the fastening bolt and take the wheel frame off the handle.
ATTENTION: Be careful not to press the main switch when attaching or removing the wheels.
This could cause serious injuries.
Assembly and disassembly of the telescopic pole (see pic. 3)
Slide into the blade handle so that it is secured with the safety lock. The safety switch and the main
switch on the handle will not function if the telescopic pole is mounted on the tool.
To remove the telescopic pole, press the safety lock and slide the swivel handle from the machine.
5. PUTTING INTO OPERATION
Operating the tool
ATTENTION: Never remove or interfere with the function of the starting mechanism.
The start safety lock prevents your tool from being started accidentally.
Working without the telescopic pole
1. Press the release button (1) backwards and press switch (2).
2. Release the release button (1).
Note: If while using this tool the LED indicator light (3) is red, the battery is fl at. Immediately stop
work and recharge the battery in the charger supplied with this tool.
Working with the telescopic pole
The length of the telescopic pole is adjustable and can be adjusted to the height of the operator.
ATTENTION: Do not use the tool's main switch when adjusting the telescopic handle. This could
cause serious injuries.
1. Attach the telescopic pole.
2. Hold the pole with one hand and then loosen the locking bolt.
3. Set the handle to the desired height and secure the pole with the adjustment bolt.
4. Press in the safety lock and press the main switch.
5. After the machine is running you may release the safety switch.