FloAire HOT WATER COIL MODULE - Manual (Page 3)

FLUID IOM
1
Guidelines for the installation, operation and maintenance of Heatcraft’s cooling and heating coils
have been provided to help insure the proper performance of the coils and their longevity. These are
general guidelines that may have to be tailored to meet the specific requirements of any one job. As
always, the installation and maintenance of any coil should be performed by a qualified party or
individual. Protective equipment such as safety glasses, steel toe boots and gloves are recommended
during the installation and routine maintenance of the coil.
Receiving Instructions
1. All Heatcraft coils are factory tested, inspected and carefully packaged.
2. Damage to the coils can occur after they have left the factory. Therefore, the coils
should be inspected for shipping damage upon receipt. The freight bill should also be
checked against items received for complete delivery.
3. Damaged and/or missing items should be noted on the carrier’s freight bill and signed by
the driver.
4. For additional assistance, contact your local Heatcraft representative.
Nomenclature
5 W S 14 06 C 24.00 x 144.00
Tube O.D. Finned Length (inches)
4=1/2”
5=5/8”
Fin Height (inches)
Coil Type Fin Design
W Standard Water A - flat (Al, Cu)
M Splayed Headers B - corrugated (Al, Cu)
B Booster C - sine wave (Al, Cu)
K Cleanable Both Ends F - flat (SS, CS, Al, Cu)
P Cleanable Supply End G - corrugated (SS, CS, Al, Cu)
Q Cleanable Opp. Supply End H - sine wave (SS, CS, Al, Cu)
Circuiting Rows Deep
Q - 1/4 serp M - 1 1/2 serp
H - 1/2 serp D - 2 serp
L - 3/4 serp T - 3 serp Fins Per Inch
S - 1 serp B - skip tube
Booster
S - 1 circuit
B - skip tube
D - 2 circuits