Flyzone FLZA4004 - Manual (Page 11)

11
2. Move the elevator up with the transmitter and
measure the distance it moved from center. This is the
“up” elevator throw.
These are the recommended control throws:
ELEVATOR
11/16"
[17.5mm]
Up
11/16"
[17.5mm]
Down
RUDDER
13/16"
[20.6mm]
Right
13/16"
[20.6mm]
Left
FLAPS
3/8"
[9.5mm]
Down
AILERONS
5/16"
[7.9mm]
Up
5/16"
[7.9mm]
Down
3. If the elevator throw is not set according to the
measurements provided, use the adjustments in your
transmitter to adjust the throws (according to the instructions
that came with your radio system).
4. Measure and set the rest of the throws the same way. When
setting the fl ap throw, if using the Tactic radio suggested, use
the adjustment screw in the front of the transmitter to change
the throw.
Final Assembly
❏
1. Slide the propeller back plate onto the motor shaft. Make
certain the molded-in cavity captures the nut on the shaft.
Add the propeller and washer. Add a drop of threadlocker
to the threads. Then, thread on the nut, tightening it with a
5.5mm wrench or a small pliers.
❏
2. Install the spinner cone and attach with two 2.5 x 8mm
Phillips screws.