Flyzone FLZA4004 - Manual (Page 6)

6
❏
3. With the pushrods connected to the elevator and
rudder, and making certain the pushrods are not crossed,
feed the pushrods up through the guide tubes in the fuselage
as you simultaneously slide the stab/fi n assembly forward
(but not yet all the way into position). When you get about
halfway, guide the wire for the light in the fi n up through the
tube in the fuselage as well.
❏
4. Just before the fi n and stab are all the way into
position, reach inside the fuselage with small needle-nose
pliers or hemostats and feed the pushrods into the pushrod
connectors already mounted on the servos.
❏
5. Fit the fi n and stab assembly the rest of the way into
position on the back of the fuselage and tightly push them
down into position.
❏
6. Move the rudder back-and-forth and the elevator up-
and-down to make certain everything is operating smoothly.
If there is much resistance or if something doesn’t seem right,
remove the fi n and stab from the fuselage and make sure
you have the pushrods hooked up correctly. Then reinstall
and try again.