Flyzone FLZA4032 - Manual (Page 8)

8
Adjust the Control Surfaces
❏
1. Before mounting the wing, the control surfaces must be
mechanically centered if they are not already. With the fl ight
battery plugged into the ESC and your transmitter on, confi rm
that the trims are centered on the transmitter. Move the left
control stick to the left and confi rm the rudder moves left. If
it moves right, fl ip the rudder (channel 4) reversing switch on
your transmitter if you are using the TTX600. If you are using
a different model transmitter, consult your radio manual. View
the model from behind to see if the rudder is aligned with the
vertical fi n (centered). If not, loosen the screw in the rudder
servo screw-lock connector and adjust the rudder pushrod
in the connector until the rudder is centered. When satisfi ed,
tighten the screw.
❏
2. Move the right control stick down and confi rm that
the elevators move up. If not, fl ip the elevator (channel 2)
reversing switch on your transmitter. As you did with the rudder,
mechanically center the elevator if necessary.
❏
3. Moving the right control stick to the right should cause
the right aileron to move up and the left aileron to move down.
If not, fl ip the aileron (channel 1) reversing switch on your
transmitter. Mechanically center the ailerons.
Check the Retracts
❏
1. Mount the wing onto the fuselage using the 4x 30 mm
screw. Be sure the excess servo leads are pulled out of the
way of tail servo arms and that they are not caught between
the wing and the wing saddle as the wing is seated onto
the fuselage.