Transmitter, Before operating batteries for transmitter, Charging the battery – Flyzone FLZA2100 User Manual

Page 3: Turning the power on

Advertising
background image

3

TRANSMITTER

Power Switch

Rudder Stick

(Left/Right)

Controls the left/right

direction of the

airplane’s nose.

Throttle Stick (Up/Down)

Battery Level

Indicator

Charge Lamp

Battery

Hatch

Charger

Terminal

Hatch

Rudder Trim

(Left/Right)

Adjust left/right so

plane flies straight.

The right stick

(elevator control

forward and back
movement) is not

used for the INUM.”

Controls propeller

speed and altitude,

climbing and

descending.

BEFORE OPERATING

Batteries for Transmitter

Open the

Battery Hatch

Install 4 "AA" size
Alkaline batteries
following the polarity
markings.

Close the

Battery Hatch

Charging the Battery

Read Page 2 carefully and charge the battery accordingly.

● Use only the battery charger in the transmitter.
● Do not attempt to charge a damaged battery. This may

cause fi re or serious damage.

● For safety reasons, batteries with a high voltage cannot

be recharged. Run down the battery completely and
then recharge.

Charge Lamp

Charge Socket

3.7V 35mAh LiPo Battery

1. Open the charger terminal hatch by carefully pushing the

small tab to the left.

2. Connect the 3.7V 35 mAh LiPo battery to the charge socket.

3. The red charge lamp lights up and quick charge commences.

(Fully discharged battery takes about 30 minutes to charge.
Charging time can vary).

4. When red charge lamp goes off, charging is complete.

● When the AA transmitter cells are getting low in voltage,

the battery will not be charged. Change to new AA cells
before charging or fl ying.

● The battery can be charged whether the transmitter power

is switched ON or OFF.

Turning the Power On

Ensure that the throttle stick is in the “all the way down” position.

A spinning propeller can be dangerous.

Always turn the transmitter’s power switch ON fi rst!

1

2

3

B

ee

p B

eep

Be

ep

Replace
batteries

1. Move the throttle stick all the way down.

2. Switch the power ON

3. The green lamp lights up and you will hear 1 beep. If

you hear 2 beeps, replace the AA batteries.

● Unless the throttle stick is not moved all the way to the

bottom, the motor will not operate.

Advertising