Flyzone FLZA3634 - Manual (Page 4)

4
❏
5. Position the parts onto the fuselage, making sure that the vertical fin is being glued square to the horizontal stabilizer. The
parts can be taped in place while the epoxy cures.
❏
6. Insert the 90° bend (at the aft end) into the outer hole of the elevator control horn. Secure it using the 90° pushrod connector.
Make a small, upward bend in the elevator pushrod as shown. Fit the pushrod through the screw-lock connector and attach the
servo arm to the servo using the servo arm screw. Use your radio system to center the elevator servo. Position the elevators in
the neutral position and securely tighten the screw-lock connector against the pushrod.
❏
7. Attach a dual servo extension to the aileron servo leads.
Connect the dual servo extension, elevator servo lead and ESC
to the receiver. Bundle the excess servo leads out of the way
of the elevator servo and use the included self-adhesive hook
and loop material to secure the receiver to the side of the radio
compartment as shown.
❏
8. Apply the hook side of the included self-adhesive hook
and loop material in the radio compartment (depending on the
battery height, you may need to attach the hook and loop on
the side as shown). Brushing on a thin coat of epoxy and letting
it cure before attaching the hook material will help it adhere to
the foam. Apply the loop side to your battery pack.