Flyzone FLZA3322 - Manual (Page 19)

19
ADJUSTABLE STICKS
The length of both gimbal sticks can be adjusted as desired.
Loosen the set screw inside the center of the stick with a
2mm hex wrench. Rotate the stick end counter-clockwise to
lengthen the stick, or clockwise to shorten the stick. Once
the desired stick length is found, tighten the set screw with
the hex wrench.
CHARGE JACK
WARNING!! Do NOT attempt to recharge
alkaline batteries! The charge jack should
ONLY be used if rechargeable cells are used
in the transmitter.
The TTX404 includes a built-in charge jack for convenient
recharging of NiCd or NiMH batteries, and is compatible
with charge leads designed for Futaba
® brand transmitters.
(HCAP0101) This jack is NOT compatible with charge leads for
Hitec ® , Airtronics ® , JR ® or Spektrum ® radios. The compatible
charge plug is shown in the picture below.
To use the charge jack with optional rechargeable batteries,
fi rst remove the sticker that covers the charge jack on the
side of the Tx – making sure not to allow any object to be
inserted inside the jack itself. Next, insert the cells inside
the Tx’s battery compartment noting proper polarity. Make
sure the transmitter’s power switch is in the OFF position.
Connect a compatible charge lead to the jack and follow the
instructions included with the charger for charging of NiCd or
NiMH batteries that are rated at 4.8V.
Tactic’s optional TACP1000 rechargeable battery and wall
charger kit includes eight “AA” size rechargeable NiMH cells
and 110V AC wall charger. It is compatible with this Tx and
can be found at local retailers. Make sure to follow the
instructions included with the charge kit.
WARNING!! It’s not recommended to charge
batteries at greater than 1 amp through this
charge jack. Fast charging of NiCd and
NiMH batteries should ONLY be done with
chargers that are specifi cally designed to include the
peak-detection function which can automatically stop
charge when full charge is detected. Misuse, improper
charging, or over-charging of rechargeable cells can
result in damage to the cells that could include cell
rupture, explosion, or fi re!!
TRAINER FUNCTION
The TTX404 Tx includes a built-in wireless trainer function
– no trainer cable required! This trainer system connects a
teacher’s Tactic Tx to a student’s Tactic Tx by wireless
connection. Tactic’s wireless trainer function is not compatible
with trainer systems in any other brand radios.
IMPORTANT! Before attempting to fly the
airplane, it’s very important to make sure all
reversing switches and trim lever adjustments
on the student’s Tx match the settings on the
teacher’s Tx! Otherwise, the airplane could suddenly veer
off in an unwanted manner when the teacher’s trainer switch
is pressed. Proper matching of the student and teacher’s Tx
settings should ensure that no unexpected movements occur
when the trainer switch is pressed. This is especially true of
the throttle control!
1. The Tx that was used to setup the controls on the aircraft
must be used by the TEACHER.
2. The student must use a separate Tactic Tx with wireless
trainer function.
3. Place the teacher and student’s transmitters within 1
meter of each other, and make sure the throttle stick
for each Tx is set to idle.
4. Turn ON the power switch for the Tx being held by the
student.
5. Pull and hold the trainer switch on the teacher’s Tx, and
then turn ON the teacher’s Tx power switch.