Flyzone FLZA3014 - Manual (Page 5)

5
● Never charge the battery in the plane.
● We recommend that a balancing charger be used to charge
the battery. A properly cared for battery will last a long time. If
the battery pack is continually charged without balancing the
individual cells, the life of the battery pack will be shortened.
Battery Recycling
Attention: The Sensei is powered by a rechargeable battery.
At the end of the battery’s useful life, under various state and
local laws, it may be illegal to dispose of the battery into the
municipal waste system. Check with your local solid waste
offi cials for details in your area for recycling options or proper
disposal. We encourage contacting your local recycling center
for more information.
Install the Receiver
If you are assembling the Sensei RTF, skip to the next column
and start at ASSEMBLE THE SENSEI.
❏
1. Plug the Y-harness into the aileron channel, channel-1
on the Tactic receiver.
❏
2. Plug the elevator servo into channel-2 on the Tactic receiver.
Plug the rudder servo into channel-4 on the Tactic receiver.
❏
3. Plug the throttle into channel-3 on the Tactic receiver.
If you will be using the drop doors, plug the servo into the
receiver’s retract channel or channel-5 on the Tactic receiver.
❏
4. Peel the backing from one side of the double-sided tape.
Attach it to the back of the receiver. Peel the backing from the
other side of the double-sided tape and attach the receiver to
the front of the servo compartment. Route the excess rudder
and elevator servo wires under the servo tray. The throttle and
drop door servo wires should be positioned so they do not
interfere with the rudder and elevator control rods.
ASSEMBLE THE SENSEI
Install the Main Landing Gear
❏
Attach the main landing gear to the fuselage using two
3x16mm sheet metal screws. Note that the landing gear is
angled forward.