Flyzone FLZA3014 - Manual (Page 6)

6
Install the Vertical and
Horizontal Stabilizer
❏
1. Flex the elevators up and down a few times to loosen
them up so they move easier.
❏
2. Repeat the process to loosen the rudder.
❏
3. Insert the rudder control arm through the V-bend in the
elevator joiner wire. Note that the plastic plate is on top of
the stabilizer.
❏
4. Insert the three guide posts into the three recesses in
the top of the horizontal stabilizer.
❏
5. Slide the assembly into the recess in the top of the
fuselage. Then, press the assembly down to seat it against
the fuselage.
❏
6. Insert the 3 x 25mm machine screw into the hole in the
bottom of the fuselage. Thread the 3 x 25mm machine screw
through the horizontal stabilizer and into the bottom of the
vertical fi n.