Flyzone FLZA3034 - Manual (Page 6)

6
❏
6. Insert the 3 x 25mm machine screw into the hole in the
bottom of the fuselage. Thread the 3 x 25mm machine screw
through the horizontal stabilizer and into the bottom of the
vertical fi n.
Connect the Rudder and
Elevator Controls
❏
1. Use needle-nose pliers to unsnap the 90° pushrod
connector from the rudder pushrod.
❏
2. Insert the pushrod into the inner hole of the rudder
control horn.
❏
3. Re-install the 90° pushrod connector on the pushrod.
Use needle-nose pliers to snap the 90° pushrod connector
onto the wire.
❏
4. Repeat the process to install the elevator pushrod in the
outer hole of the elevator control horn.