Flyzone FLZA3034 - Manual (Page 9)

9
switch SE for ‘CTRL’. OFFSET should remain 0% and travel
should be +100% for both values.
Open the PROGRAMMABLE MIXER option under SETTINGS.
Select ‘Mix1’ and set the values as shown in the photo. You will
be mixing CH6 into CH6. leave the ‘RATE’ values at +100%.
You must change ‘OFFSET’ to -25%. Set the ‘CTRL’ to the
SF switch. Exit out of the programmable mixer option. Both
switches are now ready to use.
RADIO SYSTEM
Check the Radio System
CAUTION: Do not install the propeller on the plane until
instructed to do so.
❏
1. Install the four AA alkaline batteries in the transmitter
with the correct polarity.
Note position of
reversing switches:
❏
2. Check that the servo reversing switches are confi gured
as shown. Other model transmitters must have the servo
reversing positions determined by following the procedure
in this section.
❏
3. Position the throttle stick (left stick) to idle (all the way
down) and switch on the transmitter. The power indicator light
should be glowing a steady red. A fl ashing red light and an
audible tone indicates low voltage. If this happens, replace
the batteries before connecting the fl ight battery.
❏
4. Center the aileron, elevator, throttle and rudder trims on
the transmitter by listening to the beeps. You will hear a low,
short beep each time you bump the trim. When you hear one
high, short beep the trim is centered. Experiment running the
trim to the limits a few times to familiarize yourself with the
trims. When fi nished, return all the trims to center.
❏
5. With the transmitter still switched on, connect the LiPo
motor battery to the electronic speed control. The motor will
produce a low tone. Moving the right stick on the transmitter
up and down will move the elevator on the plane up and down.
If the motor does not beep and the elevator does not move,
the receiver will need to be bound to the transmitter.