Flyzone FLZA3312 - Manual (Page 7)

7
● Remember to check the temperature of the battery during
the charge. The battery should not get hot. If it does, unplug
the battery from the charger.
● Charge the battery at a maximum charge rate of 1.8 amps.
A higher charge rate will cause the battery to get hot.
● Never place the battery on combustible material or leave it
unattended while charging.
● Never charge the battery in the plane.
● We recommend that a balancing charger be used to charge
the battery. A properly cared for battery will last a long time. If
the battery pack is continually charged without balancing the
individual cells, the life of the battery pack will be shortened.
Battery Recycling
Attention: The AcroWot MKII is powered by a rechargeable
battery. At the end of the battery’s useful life, under various
state and local laws, it may be illegal to dispose of the battery
into the municipal waste system. Check with your local solid
waste offi cials for details in your area for recycling options or
proper disposal. We encourage contacting your local recycling
center for more information.
ASSEMBLE THE ACROWOT MKII
❏
1. Install the main landing gear onto the fuselage using
two 3x15mm machine screws and thread locking compound.
Note the orientation of the gear in the photo.
❏
2. Slide the horizontal stabilizer into the slot in the fuselage.
Align the holes in the stab with the holes in the fuse.
❏
3. Fit the vertical fi n in place, making sure it is fully seated
in the notch in the fuse.
❏
4. Secure the fi n and stab in place with two 3x18mm
machine screws as shown.
❏
5. Fit the tail wheel assembly onto the underside of the
fuse and push the tail wheel tiller wire into the molded groove
in the rudder. Secure the tail wheel assembly with a 2x10mm
self-tapping screw.