Flyzone FLZA3312 - Manual (Page 9)

9
❏
10. Connect the Y-harness attached to the aileron servo
leads to the receiver. Fit the wing in place on the fuselage
and secure it using a 4x12mm machine screw.
❏
11. As you did with the elevators and rudder, center the
ailerons and tighten the screws in the aileron servo arms with
thread locking compound, with the Rx powered.
❏
12. Fit the spinner backplate onto the prop adapter shaft
followed by the propeller, prop washer, and prop nut. Thoroughly
tighten the nut onto the shaft. Install the spinner cone onto
the backplate with the included screws.
❏
13. Fit the fl ight battery into the battery compartment in
preparation for checking the center of gravity of the plane.
Install the battery hatch in place.