Flyzone HCAA1994 - Manual (Page 10)

be short of the landing area, turn the motors back on
for a couple of seconds to lengthen your approach. To
do this push the left stick forward.
4. As the MICRO ULTRIX slowly descends, use the
right stick to control the direction. The MICRO ULTRIX
will just about land itself. All you need to do is control
its direction by moving the right stick from side to side.
Move the switch on the side of the fuselage to the
“OFF” position. Then, switch the transmitter off. Allow
the airplane battery to cool before recharging. Check
the plane over to make sure nothing has come loose.
Even the best R/C pilots in the world damage their
planes every now and then. In the unfortunate event
that you damage your airplane, repairs are fairly
simple to make yourself. If there are any cracks in the
wing or fuselage, apply 6-minute epoxy or white glue
to the broken area and hold together with clear
packaging tape. Let the glue cure, leaving the tape in
place for added strength.
Replacement parts for your MICRO ULTRIX.
To order replacement parts for your MICRO ULTRIX,
use the order numbers in the list below. Replacement
parts are available only as listed. Replacement parts
are not available from Product Support, but can be
purchased from hobby shops or mail order/Internet
order firms. If you need assistance locating a dealer
to purchase parts, contact:
Product Support
Phone: 217-398-8970 Fax: 217-398-7721
E-mail: [email protected]
If any parts are missing or are not of acceptable quality,
or if you need assistance with assembly, contact
Product Support. When reporting defective or missing
parts, use the part names exactly as they are written in
the parts list.
Stock Number Description
HCAA3256 MAIN WING
HCAA3257 TAIL SET COMPLETE
HCAA3258 PROPS (4)
HCAP9916 DC CHARGER
HCAA3264 DECAL SET
❏
1. Check the area to make sure no one is on
your frequency.
❏
2. Charge the airplane battery.
❏
3. Switch on the transmitter and extend the antenna.
Make sure the green light is on.
❏
4. Move the switch on the airplane to the
“ON” position.
❏
5. Move the left stick forward and launch
the airplane.
Cut out or copy and tape to back of transmitter.
❏
1. Switch off the airplane.
❏
2. Switch off the transmitter.
❏
3. Check over the airplane, making sure nothing
came loose.
AFTER LANDING
BEFORE FLIGHT CHECK LIST
PARTS LIST
REPAIRS
AFTER THE FLIGHT
10