Flyzone HCAA1994 - Manual (Page 4)

❏
3. Reinstall the battery hatch, switch on the
transmitter and check the LEDs on the front of the
transmitter. If the green light is on, it is safe to fly. If
not, you need to install fresh batteries. Also check to
make sure that the batteries are installed correctly.
CAUTION:
Do not use rechargeable (NiCd) batteries.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd) batteries.
❏
1. Remove the battery hatch from the charger by
removing the latch screw with a Phillips screwdriver.
❏
2. Following the diagram in the charger, install six
“C” size batteries. Make sure the positive (+) and
negative (–) poles match up correctly with the
diagram molded inside the battery compartment.
❏
3. Reinstall the battery hatch by replacing the
screw, switch on the charger and check that both
green LEDs on the top of the charger are lighted. If the
green lights are on, the charger is ready to be used. If
no lights come on check to make sure that the
batteries are installed correctly. If they are, you need
to install fresh batteries.
INSTALL BATTERIES IN THE CHARGER
4