Flyzone HCAA1993 User Manual
Page 10
Biplane will be short of the landing area, turn the
motors back on for a couple of seconds to lengthen
your approach. To do this push the left stick forward.
4. As the MICRO ULTRIX Biplane slowly descends,
use the right stick to control the direction. The
MICRO ULTRIX Biplane will just about land itself. All
you need to do is control its direction by moving the
right stick from side to side.
Move the switch on the side of the fuselage to the
“OFF” position. Then, switch off the transmitter. Allow
the airplane battery to cool before recharging. Check
the plane over to make sure nothing has come loose.
Even the best R/C pilots in the world damage their
planes every now and then. In the unfortunate event
that you damage your airplane, repairs are fairly
simple to make yourself. If there are any cracks in
the wing or fuselage, apply 6-minute epoxy or white
glue to the broken area and hold together with clear
packaging tape. Let the glue cure, leaving the tape
in place for added strength.
To order replacement parts for your MICRO ULTRIX
Biplane, use the order numbers in the list below.
Replacement parts are available only as listed.
Replacement parts are not available from Product
Support, but can be purchased from hobby shops or
mail order/Internet order firms. If you need assistance
locating a dealer to purchase parts, contact:
Product Support
Phone: (217) 398-8970 Fax: (217) 398-7721
E-mail:
If any parts are missing or are not of acceptable
quality, or if you need assistance with assembly,
contact Product Support. When reporting defective
or missing parts, use the part names exactly as they
are written in the parts list.
Stock Number
Description
HCAA3250
Wing Set
HCAA3249
Tail Set
HCAA3258
Props (4)
HCAP9930
DC Charger
❏
1. Check the area to make sure no one is on
your frequency.
❏
2. Charge the airplane battery.
❏
3. Switch on the transmitter and extend the
antenna. Make sure the green light is on.
❏
4. Move the switch on the airplane to the
“ON” position.
❏
5. Move the left stick forward and launch
the airplane.
Cut out or copy and
tape to back of transmitter.
❏
1. Switch off the airplane.
❏
2. Switch off the transmitter.
❏
3. Check over the airplane, making sure nothing
came loose.
AFTER LANDING
BEFORE FLIGHT CHECK LIST
REPLACEMENT PARTS
REPAIRS
AFTER THE FLIGHT
10