Futaba 3PK User Manual

Page 24

Advertising
background image

Anti-Lock Braking

ABS

Levels

LV2, LV3 Only

DEFINITIONS:

•

ABS: Simulates a full size car’s antilock braking by pulsing the brake on and

off rapidly.

•

ABP: Amount of brake return, how far the braking response is decreased

during the pulses.

•

DLY: Delay; determines how long the braking is applied before ABS begins

to operate.

•

CYC: Cycle speed adjustment, sets how rapidly the brakes cycle from full

brake to ABP and back.

•

TGP: Trigger point, sets at what point ABS will be activated. ABS does not

respond if less brake is provided than the trigger point setting.

•

DTY: Cycle duty ratio, sets the proportion of the total cycle spent with brakes

applied full vs. ABP.

•

STM: Steering mix setup, controls when the ABS is triggered based upon amount of steering input. Designed to

decrease skidding when vehicle is in a turn, and minimize spin outs.

AVAILABLE FOR: Braking only.

ADJUSTABILITY:

•

ABP: 0 (no ABS) to 100% [Servo goes to neutral (no brake) during pulse].

•

DLY: 0 (ABS responds immediately) to 100% (1.7 seconds of full brake before ABS takes over).

•

CYC: 1 (fastest) to 30 (slowest). Default=10.

•

TGP: 10-100.

•

DTY: -3 (longest full brake application — most likely to skid) to + 3 (shortest full brake – least likely to skid).

•

STM: OFF, N10-N100, E10-E100.

•

MODE:Inhibited, Active but switch is off, Active and switch is on.

•

Switch assignment can be changed in

FUNC-SW (see pp. 34-35).

•

Each ABS variable can be assigned to dials in

FUNC-DIAL (pp. 34-35) for on-the-course adjustability.

INTERACTIONS:

•

EPA, servo reversing, dual rates, Speed Limiter, acceleration, auto-start, and exponential all interact to create the
overall braking effect.

•

Brake mixing works with ABS as if only one brake servo were used. No second setup for ABS is required.

•

Trigger point, steering mix and assigned switch each control ABS. All three must “say OK” for ABS to respond.

DESIRED END RESULT: Model stops as rapidly as possible without skidding.

CAUTIONS:

•

Careful analysis of the problem causing skids is required to adjust the proper portion of ABS for best results.

•

Adjustments to EPA, auto-start, expo, speed, brake mixing, vehicle’s suspension, tire compounds, engine
tuning and ATL will all affect the performance of the ABS settings.

24

Advertising