Futaba 3PK User Manual

Page 28

Advertising
background image

Auto-start Throttle Settings and Engine Cut

AT-START

Levels

LV2, LV3 Only

DEFINITIONS:

•

Auto-start: A pre-set throttle position, less than full throttle, to be used for the
initial acceleration off the line without having wheel spin. When the trigger is
released, auto-start is turned off and throttle operates normally again.

•

ATS: Auto-start status.

•

Engine Cut: Shuts the engine off without having to adjust the throttle trim. Takes
the throttle servo to a preset position when the switch is pressed. (Not available
to models using braking/reverse from the throttle servo. Primarily for boats.)

•

TG.P: Trigger point at which auto-start is activated.

•

PRST: Preset throttle servo position when function is activated. Preset is a

“true” preset – it is not a mix or a portion of the EPA. It is truly a
command to move the servo to a set position regardless of other inputs,
including trigger.

•

MODE: Which function is being utilized at this time. (Engine cut and auto-start can not be used together).

•

AT&SW: Auto-start is activated by throttle trigger or switch. Switch can be assigned in FUNC-SW (pp. 34-35) and

used to turn on/off the auto-start feature without having to pull or release the throttle trigger to do so.

•

INH:

Inhibited. Function is electronically inhibited and will not operate until changed to another setting.

•

SW:

Switch operated. Auto-start is inhibited and engine cut is available. (Assigned in

FUNC-SW, pp. 34-35.)

AVAILABLE FOR: Throttle servo only.

ADJUSTABILITY:

•

M

MOODDEE: Inhibited, switch only (engine cut), auto-start with switch override (autostart).

•

AATTSS:

Inhibited, off (not available until set), ready (will activate on next trigger pull), active (operating now).

•

TTG

GPP:

Inhibited, 5-95. Default: 5.

•

PPRRSSTT: Brake 100-1, 0, Forward 0-100. Default: 0.

•

Auto-start may be assigned to a switch. Engine cut must be assigned to a switch to operate. (See

FUNC-SW, pp. 34-35.)

INTERACTIONS:

•

EPA has NO effect on the preset position. The preset position may exceed EPA. Be sure to set auto-start after setting EPA.

•

Servo reversing DOES change the direction of the preset in this function.

•

No other function affects the preset except servo reversing.

•

Trigger position has no effect on engine cut. Engine cut will shut engine to the preset position regardless.

•

Auto-start must be restarted for each use by going to the auto-start function and pressing the + and – keys together
for one second while ATS is selected, or assigning and holding on a switch. (See

FUNC-SW, p. 34-35.)

•

If throttle triggered, auto-start remains active once started until the throttle trigger is returned to neutral.

DESIRED END RESULT: Avoiding wheel spin on starts and shutting engine off safely.

CAUTION: Remember that preset is not relative to EPA, so always check for binding if other changes have been made.

28

Advertising