Futaba 3VCS - Manual (Page 46)

47
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
MENU
Setup items
ABP
: Brake return amount
DLY : Delay amount
CYC : Cycle speed
MODE : Function ON/Off
THP
: Operation point
DTY : Cycle duty ratio
STM : Steering mixing
* When brake operation enters the set
range, "*" is displayed in front of the
number.
* When steering mixing is set and
steering operation enters the set
range, "*" is displayed in front of the
number. When mixing is OFF, the
A.B.S function can operate over the
entire steering range.
* A bar graph that shows the oper-
ating position of the throttle stick
appears. During setup, A.B.S func-
tion operation can be checked at
this bar graph.
Delay amount
0 ~ 100
Initial value; 0
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Brake return amount
0 ~ 50 ~ 100
Initial value; 50
0% 100%
A.B.S. Function
A.B.S function adjustment
(Preparation)
- Select setup item "MODE" and make the following ad-
justments:
1 (Function ON/OFF)
Set the function to the active state by pressing
the (+) or (-) button.
"INH(OFF)" : Function OFF
"ACT(ON)" : Function ON
"ACT(OFF)" : Switch OFF when setting switches
2 (Brake return amount adjustment)
Select setup item "ABP" by pressing the (UP)
button 3 times and use the (+) and (-) buttons to
adjust the return amount.
"0" : No return
"50" : Return to the 50% position of the brake operation amount
"100" : Return to the neutral position.
3 (Delay amount setup)
Select setup item "DLY" by pressing the (DN)
button once and use the (+) and (-) buttons to
adjust the delay amount.
"0" : A.B.S. function performed without any delay
"50" : A.B.S function performed after an approximate 0.7 sec delay.
"100" : A.B.S. function performed after an approximate 1.7 secs delay.
Function ON/OFF
INH(OFF), ACT(ON), ACT(OFF)