Futaba 6XHS - Manual (Page 8)

TRANSMITTER CONTROLS – AIRCRAFT (T6XAs System)
Elevator Dual
Rate Switch (A)
Flap Knob (Ch. 6)
Aileron Dual
Rate Switch (C)
Airbrake Switch (B)
Antenna
Landing Gear
Switch (Ch. 5,
Sw. E) Elev -> Flap
Mixing Switch
(D)
Carrying
Handle
Liquid-Crystal
Display
Trainer Push-
button Switch
ON indicator
light
Rudder / Throttle
Stick
Throttle Trim
Rudder Trim
Crystal Cover
Neckstrap Hook
Elevator Trim Lever
Aileron / Elevator
Stick
Aileron Trim Lever
Programming Keys
Charging Jack
On-Off Switch
COMPUTER RADIO
PCM / PPM SELECTABLE
Fun to Fly
This figure shows the default assignments for a Mode 2 aircraft system as supplied by the factory.
SWITCH ASSIGNMENT TABLE
The functions activated by the switches and knobs for a Mode 2 transmitter are shown in the
table below. Note that some of the functions will not operate until activated in the mixing
menus. For a Mode 1 transmitter, elevator and throttle are reversed, as are switches D and E.
Switch / Knob ACRO HELI
Switch A Up = Elevator Dual Rate 1;
Down = PMX1 & PMX2 on; Elev D/R 2 Up = Elevator Dual Rate 1;
Down = Elev D/R 2
Switch B Down = Airbrake on Gyro sensitivity (if desired)
Switch C Up = Aileron Dual Rate 1
Down = Aileron Dual Rate 2 Up = Aileron Dual Rate 1
Down = Aileron Dual Rate 2
Switch D Forward = 2 -> 6 (Elev -> Flap) on Forward = Throttle Hold on, and
REVO off
Switch E Landing Gear Forward = Idle-up on, Rudder
offset on, and REVO off
Switch F
(Push-button)
Trainer Trainer
CH6 knob Flap or Flap trim if flaperon function
(FLPR) on Hovering Pitch
– 3 –