Futaba GY701 Quick Start - Manual (Page 11)

T
AIL
R
OTOR
S
ERVO
I
NSTALLATION
11
onto the servo ensuring that it is perpendicular to
the tail rotor pushrod. Install the servo arm screw.
(Depending on T/R
linkage geometry)
13.25 −16.5 mm
Carefully hold the tail rotor pushrod ball link
onto the servo arm and verify that the tail rotor
operation matches the transmitter stick input. If
necessary, reverse the operation direction within
your transmitter.
Press the mode [+] key until “GY.Dir Normal”
is shown on the screen. Carefully hold the tail
rotor pushrod ball link onto the servo arm. Rotate
the helicopter counter clockwise (or what would
normally be left tail rotor) and ensure that the gyro
compensates by adding right tail rotor. If the gyro
compensates the incorrect direction, then press the
data [+] or [–] key until the gyro compensates the
correct direction.
Gyro direction [default: Normal]
The gyro compensation direction is changed
by pushing the data + or – key.