Futaba GY701 Quick Start - Manual (Page 5)

5
C
ONTROL
B
OX
I
NSTALLATION
(1) Gyro: 1
2
3
Gyro
s Connect the gyro sensor.
*Insert the sensor
connector until it is
firmly locked.
Receiver
(2) Rin/SB:
s S.BUS receiver: Connect to the S.BUS out-
put of the receiver.
s Other than S.BUS receiver: Connect to the
rudder channel output. Gyro
(3) Gain: Gyro
s Connect to the gyro gain channel output.
Find a suitable location for the GY701 control box
and mount it using double sided tape. Connect the
gyro sensor to the [Gyro Rsen] connector on the
control box and ensure the clip is fi rmly engaged.
Connect the supplied extensions to the GY701
connecter. Route the wires through the helicopter
mechanics and connect them to the appropriate
receiver channels. If you are using a standard
receiver, then the only two connections needed
are Receiver Tail Rotor Channel
➞ GY701 [Rin]
connection and Receiver Gain Channel
➞ GY701
[Gain] connection. To determine the appropriate
receiver channels, please check your transmitter’s
instruction manual.
If using a Futaba S.Bus receiver, then only one
extension is needed between the S.Bus Receiver
connection and the GY701 [SB] connection. If
any other information is needed please see the
“S.Bus Basic Setting” section of the GY701
Instruction Manual.