Audio connections, Pointing device connection, Installation – Philips CDI550 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
4. AUDIO CONNECTIONS
If you use the video (C\T5S) (10) output, you also will need
to connect the player's audio output (8,9) to the TV's audio
input.
/
Ui
iimBHiimiiiiHii
For HiFi sound, you can connect the player’s audio output
(8,9) to the input of your HiFi system.
NOTE
The sound sent through the RF output to your TV is mono
only.
CAUTION
DO NOT CONNECT THE PIAYER’S AUDIO OUTPUT TO THE
mn PHONO (RECORD PIAYER) INPUT.
5. POINTING DEVICE CONNECTION
INCLUDED POINTING DEVICE: The CD-I Controller
To operate your CD-I player:
A pointing device is needed.
Plug the CD-I controller connector into the CD-I player .
Insert the connector with the arrow at the top.
Then you can switch on the player.
Move the cursor in the direction you want by pressing in that
direction on the thumbpad.
Click on one of the action buttons.
The function selected by this "point-and-click" technique is
highlighted to confirm the selection.
OPTIONAL DEVICES: Roller Controller, Trackerball, Mouse,
Touchpad, CD-I Controller, IR-Remote kit, Splitter (refer to the
accessories page on the back of this manual).
NOTE
To "point-and-click" on any screen shown in this manual, any
one of the two action buttons of the pointing device can be
used.
The shape of the cursor may be different depending on the
program you are playing, but it is always controlled in the same
way.
Pointing devices are sensitive precision instruments. Handle
them with care, keeping in mind the following precautions:
• Avoid dropping or knocking.
• Do not use them in locations subject to extreme temperatures,
humidity, dust or vibration.
• Never hold the pointing device by the cable.
• Never pull the cable to disconnect the pointing device from
the player.
CAUTION
NEVER MAKE OR CHANGE CONNECTIONS WITH THE
POWER SWITCHED ON.
11