Philips CD 911 - Manual (Page 4)

(Ц) INSTALLATION
m
3
(Q
FITTIIMG A MAINS PLUG (U.K. only)
This apparatus is fitted
with an approved
moulded 13 Amp plug.
To change a fuse in
this type of plug
proceed as follows:
• Remove fuse cover
and fuse.
• F ix new fuse which
should be a BS1362
5A, A.S.T.A. or BSI
approved type.
• Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets. It should be cut off and an appropriate
plug fitted in its place.
If the mams plug contains a fuse, this should have
a value of 5A. If a plug without a fuse is used, the
fuse at the distribution board should not be
greater than 5A.
HOW TO CONNECT A PLUG
The wires in the mams lead are coloured in accor
dance with the following code.
BLUE -' NEUTRAL ( N ) and BROWN - LIVE I L )
As these colours may not correspond with the colour
markings identifv'ing the terminals in your plug, pro­
ceed as follows:
• The BLUE wire must be connected to the ter­
minal which IS marked with the letter N or
coloured BLACK.
• The BROWN wire must be connected to the
terminal which is marked with the letter L or
coloured RED.
• Do nof connect either wires to the earth termi­
nal in the plug which is marked by the letter' E'
or by the safety earth symbol or coloured green
or green-and-yellow.
Before replacing the plug cover, make certain that
the cordgrip is clamped over the sheath of the
lead - not simply over the two wires
NOTE
The severed plug must be disoosed to avoid a
possible shock hazard should it be inserted
into a J3A socket elsewhere.