Philips CD 911 - Manual (Page 5)

INSTALLATION
POWER SUPPLY SETTING CONNECTIONS
Check that the type plate on the rear of your
player indicates the correct supply voltage.
If your mains supply voltage is different, consult
your dealer or our Service Organisation.
Certain versions of this player are
equipped with a voltage selector
at the bottom of the player which
enables you to set the player to
the correct mains voltage yourself:
position 120 \f- for all mains voltages between
110V and 127 V.
position 230 V - for all mains voltages between
220Vand 240 V.
DIGITAL OUT
This output supplies a digital signal and can
therefore only be connected to an input which
is suitable for this signal.
Use here a lead with one cinch plug on either
end.
Never connect this socket to a non-digital
input of an amplifier, such as AUX, CD, TAPE,
PHONO, etc!
ANALOG OUT
For the connecting cable to the amplifier.
Insert a red plug into the 'R' socket and the
other plug into the 'L' socket.
Insert the two other plugs into the correspon­
ding sockets of the CD or AUX input of your
amplifier. ■
You can also use the TUNER or TAPE IN-
connection, but never the PHONO input!
ESI BUS (Enhanced System !ntelligence)
For connecting up the equipment when you
are incorporating the piayer in a HiFi system
with ESI BUS connection (e.g. the PHILIPS
900 series).
l/Vhen connecting the ESI BUS to the ESI BUS
of the HiFi system the CD player should be
switched off.