Philips FR999 - Manual (Page 20)

PLAYBACK, RECORDING
Playing a source Recording from a source
*S.
m '
1 Press POWER / STANDBY to switch on the receiver.
2 Turn SOURCE SELECT to select a source.
-►The name of the source is displayed.
• You can select the FRONT AV/GAME input by pressing
FRONT AV.
3 Start playback of the source as usual.
Adjusting the sound
• Turn VOLUME to adjust the volume.
-►I'uLUriE and the volume level between D and GO is
displayed.
1 Press BASS or TREBLE.
->■3055 or TREBLE and the actual value are displayed
briefly. Then TORfJ I'DLUiiE KND3 TO EHRNGE is
scrolled.
2 Turn VOLUME to adjust the bass or treble.
-►3055 or TREBLE and the actual value are displayed.
Note: /f VOLUME is not turned within 5 seconds or if any
other control is used, the bass or treble adjustment is
switched off.
• If a subwoofer is connected, press SUBW. ON/OFF to
increase the bass performance.
Note: In case of digital surround sound, a subwoofer signal
will only be available when supported by the source
material. •
• Press LOUDNESS to switch on or off loudness.
-►LOUDNESS is displayed if loudness is on.
If you wish to record from a source you must select it with
SOURCE SELECT. The incoming signal is reproduced by all
audio and - if the source includes a video signal - video
outputs of the receiver. The sound settings do not affect the
recording.
1 Turn SOURCE SELECT (or press FRONT AV) to select the
source from which you want to record.
-►The name of the source is displayed.
2 Prepare the desired recording appliance. It must be
connected to one of the outputs of the receiver.
3 Start recording on the recording appliance.
4 Start the playback of the source as usual.
Notes:-The audio and video signal ofVCR IN is not
reproduced by VCR OUT. The same applies to the
audio signal of CDmAPi IN to CDR/TAPE OUT.
- I/Ve recommend not using the digital output
COAX OUT of the receiver for recording from an
analog source. Use the analog output CDR/TAPE
instead.
- From a source which is connected to the
6 CHANNEL DVD/SA-CD IN audio input cannot be
recorded.
Recording from the digital output
It is possible to connect a digital recorder to the digital output of
the receiver. In this way, all signals coming from the digital
inputs can be recorded directly on the connected audio recorder.
The receiver will also convert all signals coming from the analog
inputs to the digital output.
The receiver can be used to record digitally a multichannel
surround sound audio signal (Dolby Digital or DTS), for example,
from DVD to CD-R. The receiver will convert the digital
multichannel signal into a stereo signal without loss of relevant
sound information.
Notes:- When recording a Dolby Digital or DTS signal, each
track must be recorded Individually.
- Digital recording is not possible when the digital
source material is copy-protected.
20