Cisco WIP300 - Manual (Page 55)

Wireless-G IP Phone
46 Chapter 5: Using the Web-based Utility
Settings
Sound Settings
Click the Sound Settings tab to change the IP Phone’s speaker volume, ringer settings, and warning tones. Refer to the table below for a list of options
available in the Sound Settings menu.
Option Description
Call Waiting Check to enable Call Waiting, uncheck to disable
Forward Number Enter a phone number or IP address to forward your calls to
Forward All Check to send all incoming calls to the Forward Number
No Answer Check to send calls to Forward Number when there is no answer on the IP phone
Block Caller ID Select On to block caller id’s that you previously set up in the IP phone menu
Refuse Private Select On to refuse calls that display Private Call as the User ID
Busy Check to forward calls when your phone is busy
Beep Notification Enable or disable the Beep Notification feature. When this feature is enabled, the phone will beep
every 50 seconds so that you can keep track of how long you’ve been on a call.
Hold Transfer Select SIP or DTMF Flash as the method used for transferring calls
Regional Tone Set the Regional tone setting to North America or Japan
Option Description
Speaker Volume Set the IP Phone’s speaker volume
Melody Choose one of the available ring tone melodies
Ring Volume Set the IP Phone’s ring volume
Ring Mode Set the IP Phone’s ring mode to Silent, Ring, Vibrate, or Ring + Vibrate
Warning Tone Check to enable the IP Phone’s warning tones, such as low battery