Philips AZ 2908 - Manual (Page 17)

CASSEHE RECORDER
2 Press STOP-OPEN ■ A to open the cassette compartement.
3 Insert a unprotected blank cassette with the full reel on the left
hand side.
4 Press RECORD • to start recording.
5 For brief interruptions press PAUSE II. To resume recording press
the PAUSE II key once more.
6 To stop recording, press STOP-OPEN ■ A.
Note: When recording from the radio ora CD. you can connect a
microphone and mix the sounds. Otherwise, be sure there is no
microphone connected that could disturb your recording.
Dubbing - copying from deck 2 to decki
When dubbing, it is recommended to use new batteries or to
connect the set to the AC power supply.
1 Press the HIGH SPEED DUBBING button for high speed copying.
Do not switch this selector during dubbing.
2 Insert a recorded cassette into deck 2 and a cassette which is
suited for recording into deck 1.
3 Press PAUSE II followed by RECORD • on decki.
4 To start dubbing, press PLAY ► on deck 2.
5 To stop dubbing, press both STOP-OPEN buttons ■ A.
Press PAUSE II on deck 1 if you wish to omit undesired passages.
The playback in deck 2 will continue. To restart dubbing, press
PAUSE II again.
By pressing PAUSE II in deck 2 during dubbing, a blank part will be
recorded in decki.
To avoid overheating of the set a safety circuit has been built in. Therefore your set may switch off
under extreme conditions. If this happens, release the power button and let the set cool down
before reusing it.
Environmental information
All redundant packing material has been omitted. We have done our outmost to make the
packaging easy separable into three mono materials: cardboard (box), expandable polystyrene
(buffer) and polyethylene (bags, protective foam sheet).
Your set consists of material which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packing materials, exhausted
batteries and old equipment.
17