Warning – Combi 8000 Series User Manual
Page 13
12
A
ttachment Of Infant Car Seat To Base:
Section 9 - Installation of Infant Car Seat in Vehicle
WARNING
DEATH or SERIOUS INJURY can occur
•
Use only in a rear-facing position when using this infant car seat in the vehicle.
•
Secure this child restraint with LATCH System or a vehicle seat belt as shown in this manual.
•
LATCH System or vehicle seat belt must stay tightly adjusted around car seat or base at all times. If
LATCH System or vehicle seat belt does not stay tight, read the vehicle owner’s manual and “Vehicle Seat
Belts” section in this manual.
•
Rear-facing car seat must be properly reclined:
- Too reclined can result in injury or ejection.
- Too upright can result in breathing difficulties.
•
After installing infant car seat into base, lift carrier to be sure it is securely locked.
Removal Of Infant Car Seat From Base:
Push in handle buttons on each side of handle and rotate handle to upright carry position
(see “Carry Handle Operation” section).
Lift red release handle up , rotate infant car seat forward and lift car seat from
base (fig. a).
1
2
3
(fig. a)
1
2
3
1
2
Red Release
Handle
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 13