Combi 8000 Series - Manual (Page 14)

13
Attaching Infant Car Seat To Base:
Verify that there are no objects on top of base or between base and infant car seat.
Lower car seat into base and push down on car seat to lock car seat into base (fig. b).
Test to be sure car seat is locked in base. Lift infant car seat at top of seat back
(fig. c) and at front end.
Carry handle can be moved to the vehicle use position (see “Carry Handle
Operation” section).
Adjust recline using recline indicator on the side of car seat. Line on
recline indicator MUST be in green striped zone (fig. d).
If line is not in green striped zone, adjust base (see “Base Adjustment” section), and
recheck recline of car seat. Repeat until recline indicator is in green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface during this installation.
1
(fig. b)
4
(fig. c)
WARNING
DEATH or SERIOUS INJURY can occur
• Only use the car seat LATCH System in vehicle seating locations recommended by the vehicle
manufacturer for use with LATCH and have an anchor spacing of 280 mm (11 inches).
• LATCH connectors must be secured to the vehicle LATCH anchorages only. Connection to other vehicle
components could result in the anchor tearing free in a crash.
• Never attach more than one anchor connector to a vehicle lower anchorage unless recommended by the
vehicle owner’s manual for that vehicle.
Securing Base With LATCH System:
2
3
(fig. d)
Recline
Indicator Green
Striped
Zone 5
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 14