Combi 8000 Series - Manual (Page 27)

26
Manually adjustable lap belts (fig. c) normally will hold a car seat tightly. However, in some
cases, the locking latch plate on some seat belts may slip and loosen if positioned at a
certain angle. If this happens, flip latch plate over (fig. c) and re-buckle. Test installation
again to see if lap belt stays tight. If not, move car seat to another seating location.
Lap Belts - Manually Adjustable
(fig. c)
Flip
Vehicle seat belts located forward of seat bight (fig. a & b) may not securely
hold car seat. Check vehicle owner’s manual or see vehicle dealer for car seat
installation requirements.
• If seating position is approved for use with car seat, install car seat and
check for secure installation by pulling car seat front to back. If car seat
slides forward or vehicle seat belt does not stay tight, DO NOT use these
seat belts.
Belts Forward of Seat Bight
(fig. a)
Seat
Bight
Belt Forward
of Seat Bight
Buckle
Forward of
Seat Bight
Seat
Bight
(fig. b)
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 27