Etch audio modules and signal path, 2 etch audio modules and signal path, 2etch audio modules and signal path – FXpansion EtchRed User Manual
Page 7
Etch audio modules and signal path
7
© 2012 FXpansion Audio
2
Etch audio modules and signal path
Etch Red's audio modules are arranged from left to right in the default routing configuration.
Distortion routing
It is possible to change the position of the Distortion module before (default configuration) or after
the filter stages using the Post button.
Filter routing
By default, Filter1 and Filter2 are arranged in series. It is possible to change this to a parallel
routing using the Parallel button on the Filter2 module. Parallel routing is useful for stereo
filtering.
Filter output levels
The Output module contains the final level controls for Filter1 and Filter2, labelled F1 Out and F2
Out.
Power buttons
The Drive, Filter1 and Filter2 modules feature a Power
button - deactivate it to bypass the module.
In this example, the Drive module is active (powered on)
while the Filter1 module has been deactivated (powered
off).
To bypass Etch Red entirely, you should use the standard
switch control at the top-left of the device.