Gaggia Baby - Manual (Page 13)

ENGLISH
• 11 •
Description of parts:
FIG. 01
1 Main switch
2 Hot water/brew switch (pump)
3 On/off light
4 Steam switch (temperature)
5 Correct temperature light
6 Removable water tank
7 Steam/hot water knob
8 Turbo frother steam nozzle (removeable)
9 Filterholder
10 "Perfect crema" pod fi lter
11 "Perfect crema" fi lter for ground coffee
12 Basin (removable)
13 Frothing jet device
14 Brewing head
15 Filterholder gasket
16 Shower disc holder
17 Shower disc
18 Tamper
19 Power cable and plug
20 Measuring spoon
21 Delivery spout
22 Tank cover
23 Grid (removable)
24 Cappuccino maker kit (OPTION)
25 Overfl owing protection hole
26 Level indicator for the basin
Instructions for the power supply cord
A A short power-supply cord is provided to reduce risks of
getting tangled up or tripping over a longer cord.
B Longer extension cords are available and may be used if
care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension cord
should be at least as great as the electrical rating
of the appliance.
2 if the appliance is of the grounded type, the
extension cord should be a grounding-type 3-wire
cord, and the longer cord should be arranged so
that it will not drape over the counter top portable
top where it can be pulled on by children or tripped
over;
3 If the power supply cord has a polarized plug (one
blade is wider than the other), as a safety feature,
this plug will fi t in a polarized outlet only one way.
If the plug does not fi t fully in the outlet, reverse
the plug. If it still does not fi t, contact a qualifi ed
electrician. Do not attempt to defeat the safety
feature.
4 If damaged, the power cord must be replaced by
the manufacturer or an authorised service centre.
Preparation:
1. Remove the water tank cover (22) and fi ll with cold water
to the MAX line indicated on tank (6). See FIG. 2.
N.B.: Near the word MAX on the tank there is the overfl owing
safety hole (25) in case of tank overfi lling.
The water tank can also be removed, after removing the
tank cover (22) using the handle.
Re-install tank with water and cover (22).
2. Insert plug (19) into a suitable wall outlet (see point 1
under “Caution”).
3. Turn the power switch (1) to “On”. The on/off light (3)
will switch on.
Make certain that the hot water/coffee switch (2) and
that the steam switch (4) are in the “Off” position.
Circuit Priming
N.B.: Upon fi rst use, after dispensing steam or when the
water tank is empty, the machine’s water circuit must
always be primed.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system. Place an empty cup under the
brewing head (14), do not insert fi lter holder and press hot
water/coffee switch (2) (pos. “On”).
You will hear the sound of the operating pump and after
few seconds, water will start to escape from the brewing
head (14).
Once cup is fi lled, set coffee switch (2) onto pos “Off”.