Garelick 31800 OUTBOARD MOTOR CARRIER - Manual

Assembly Instructions for
Model 31800 Motor Carrier
Form 12.122
ASSEMBLY INFORMATION
1. Check parts against parts list.
2. Read instructions completely before starting assembly.
TOOLS REQUIRED
1. Wrench adjustable to 7/16"
2. Screwdriver
3. Hammer
CAUTION: Woodblock and tubing will crush if over-
tightened.
MOTOR CARRIER ASSEMBLY
Refer to Fig. 1:
1. Slide axle (A) through large holes #1 of bottom brace tubes
(B) on each end.
2. Slide each end of axle through holes #1 of upright support
tubes (C).
3. Mount two wheels (E) on each end of axle.
4. Using hubnuts (F), secure wheels by tapping them on axle
squarely with hammer.
5. Slide loop ends of tank tiestraps (G) over upright support
tubes.
6. Attach woodblock (H) to each end of upright support tubes
by aligning holes #2, inserting four carriage bolts (I) and
securing with fasteners (J) and (K) as illustrated (finger
tighten).
Parts List
Model 31800 Motor Carrier
Ref. Factory No.
Letter Part No. Req. Description
A 51.024 1 Axle
B 51.015 2 Bottom brace, 16 1 ⁄
2
"
C 51.027 2 Upright support tube, 33 1 ⁄
2
"
E 49.096 4 Wheel
F 03.039 2 Pushnut
G 49.041 1 Tank tiestrap (2 parts)
H 51.029 1 Woodblock
I 03.003 4 1 ⁄
4
-20x3 1 ⁄
2
" carriage bolt
J 03.118 12 1 ⁄
4
" lockwasher
K 03.023 12 1 ⁄
4
-20 nut
L 51.022 2 Handle (left and right)
M 51.023 1 Bottom U
N 03.088 4 1 ⁄
4
-20x2 1 ⁄
2
" bolt
O 03.089 4 1 ⁄
4
-20x2 3 ⁄
4
" bolt
P 51.014 1 Handlebrace
Q 51.025 1 Tankholder U-tube
R 06.027 2 Poly handgrip
FIG. 1
FIG. 2
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
3/99
Refer to Fig. 2:
1. Insert handles (L) into bottom U (M).
2. Align holes #3 in assembly so that the handles will point
AWAY from each other and insert bolts (N). NOTE: DO
NOT add fasteners yet.
(over)