Garelick 71036 MOTOR TILTER - Manual

Operating Instructions for
Model 71036 Motor Tilter
Form 12.151
Insert end hook (A) into hand recess at the rear of the motor as shown in Fig. 1.
Position rubber legs (B) on the motor shroud as close to the opposite end where firm
pressure can be absorbed (see fig. 1).
NOTE: If an adjustment is necessary to fit your motor, remove screw from casting (C)
as illustrated in fig. 2 and then slide casting (C) back on tube to the position as
described above. Redrill screw hole with a 1/8" bit. Reinsert and secure screw in
position. Cut off excess tube with a hacksaw.
IMPORTANT: BE SURE MOTOR IS FREE TO TILT BEFORE PULLING BACK. USE A
SMOOTH, STEADY PULL.
FIG. 1
FIG. 2
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
12/97