Giga Tent BT 013 - Manual (Page 2)

Frame Parts
Fly Pole (X 1)
Main Pole (X 2)
(To prolong the life of your floor we suggest the use of a ground cloth cut slightly
smaller than the floor of your tent and that you select a campsite that is level and
free of rocks and roots.)
Step 1- TENT SET UP
PAT P E N DING 145 o
P.H .E NG -K OR EA
1 2 3 4
5 6
7 8 9 9 9
1 0 11 1
2
1)
2)
3)
(Figure A)
4)
(Figure B)
5)
Note: be careful not to get the pole caught while pushing as the
pole can break.
6)
7)
8)
(Figure C)
9) (Figure D)
Spread the tent body out on the ground.
Fully open all of the poles.
Carefully thread BOTH of the main poles through the BLUE pole sleeves
.
At the end of one of the main poles insert the pin attached to a ring at the corner of the tent
floor into the end of the pole .
At the opposite end of the pole start to push the pole through the pole sleeve while holding
onto the corner of the tent.
As you continue pushing the pole will start to bend. Continue to push until you can put the pin
into the end of the pole.
Repeat for the other main pole.
Attach the 4 pole clips to the poles .
Tie the cords sewn to the top of the tent around the 2 poles .