Great Planes Super Sportster Brushless EP ARF - GPMA1161 - Manual (Page 14)

14
.
INSTALL THE POWER SYSTEM
AND RECEIVER
❏
1. If you haven’t done so already, attach the prop adapter
to the motor using the screws included with the motor and
threadlocking compound. Install the motor onto the motor
mounting box using four 3x10mm machine screws, four 3mm
fl at washers, and threadlocking compound.
❏
2. Apply a thin coat of epoxy to the center of the battery
tray, side of the battery tray, and in the location of the receiver
in front of the servo tray. The epoxy will improve the adhesion
of the self-adhesive hook and loop material. Allow the epoxy
to cure undisturbed.
❏
3. Cut a piece of the hook side from the included self-
adhesive hook and loop material. Apply the piece to the
center of the battery tray.
❏
4. Make a strap to fi t your LiPo battery from the included
non-adhesive hook and loop material by overlapping the
mating ends of the material by 1" [25mm]. Feed the strap
through the slots in the battery tray as shown.