Great Planes Super Sportster Brushless EP ARF - GPMA1161 - Manual (Page 8)

8
❏
8. Thread a nylon clevis 20 complete turns onto each aileron
pushrod. Slide a silicone clevis retainer over each clevis.
❏
9. Connect the clevises to the torque rod horns. Center
each aileron and use tape or small clamps to hold them in the
neutral position. With the aileron servo arm still perpendicular
to the servo case, mark the pushrods where they cross the
holes you enlarged in the servo arm.
❏
10. Make a 90° bend at the marks on the pushrods and
cut off the excess pushrod 1/4" [6mm] beyond the bend.
Attach the pushrods to the servo arm using 90 degree
pushrod connectors. Thread the clevises up or down on
the pushrods as necessary to center the ailerons with the
servo arm centered. When satisfi ed, slide the silicone clevis
retainers to the ends of the clevises to secure them.
INSTALL THE TAIL SECTION
❏
1. Temporarily mount the wing to the fuselage using two
3x30mm machine screws and two 3mm fl at washers.
❏
2. Cut the tail support block from the aft end of the
horizontal stabilizer slot in the fuse.