Great Planes Super Sportster Brushless EP ARF - GPMA1161 - Manual (Page 15)

15
❏
5. Cut a piece from the included double-sided foam
mounting tape and attach the ESC to the side of the battery
compartment. Connect the ESC to the motor. Now would be
a good time to use your radio system and battery to confi rm
that the motor rotates in the correct direction. If the motor
does not rotate counter-clockwise when viewing it from the
front, simply disconnect any two of the three motor leads and
swap their positions.
❏
6. Cut a piece from the remainder of the self-adhesive
hook and loop material and use it to secure the receiver
in the location shown. Connect the elevator servo, rudder
servo, and ESC to the receiver.
❏
7. We used small scraps of fuel tubing we had laying
around the shop and glued them to the sides of the fuselage
to support the antennas of the 2.4GHz receiver shown in the
picture. If you are using an FM or PCM receiver, an antenna
tube is provided between the two outer pushrod tubes.
FINISH THE MODEL
❏
1. Place the cowl onto the fuselage and position it so
that it is 3/32" [2.4mm] behind the face of the prop adapter.
Temporarily installing the spinner backplate onto the prop
adapter will make this easier to measure. You may need to
ream or drill the backplate larger to fi t the shaft. When satisfi ed
with the placement of the cowl, tape it to the fuselage.