Great Planes Yak-54 3D Indoor EP ARF - GPMA1131 - Manual (Page 6)

6
PREPARATIONS
o 1. If you have not done so already, remove the major parts
of the kit from the box and inspect for damage. If any parts
are damaged or missing, contact Product Support at the
address or telephone number listed in the “Kit Inspection”
section on page 4.
BUILD THE FUSELAGE
o 1. Locate the two ABS landing gear stiffeners. Glue a
landing gear stiffener to each side of the fuselage in the
location shown.
o 2. Remove the twelve fuselage alignment jig pieces from
their surrounding foam. Note: These pieces are labeled
1,2,3,4,6, and W. There are no pieces labeled 5.
o 3. Key the rear of the horizontal fuselage into the
vertical fuselage. Then key the wing portion into the
vertical fuselage.