Great Planes Yak-54 3D Indoor EP ARF - GPMA1131 User Manual
Page 8
8
o
6. Place the base section of jig piece 2 under the wing, and
place base jig piece 6 under the horizontal stabilizer. Slide
the corresponding top sections over the fuse, as pictured.
o
7. Glue the two fuselage pieces together by gently sliding
the vertical fuselage and applying foam safe CA glue to the
seam between the two fuselage pieces. Be very careful when
gluing around the jig pieces.
DO NOT glue the jig pieces to
the fuselage. Apply some foam safe accelerator to the seam,
and allow a few moments for the glue to cure.
o
8. Apply a thin bead of foam safe CA glue to the
opposite side of the fuselage, and to the seam behind the
wing. Activate this CA and allow a few moments for the
glue to cure.
o
9. Once the glue has cured, gently turn the Yak over and
apply glue to the underside fuselage seams.