Compatible Systems INTRAPORT 2+ - Manual (Page 57)

Chapter 7 - Alternate Protocols and Security Parameters 51
AppleTalk Protocol
Required for AppleTalk
Generally, there are no required changes from the shipping Ethernet
configuration for AppleTalk. The Ethernet interface will autoconfigure
to use AppleTalk Phase 2, and will adapt to conditions on the Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to use more meaningful zone
names.
CV: Use the AppleTalk Routing: Ethernet 0 dialog box.
TB: Use configure and set keywords in the AppleTalk Phase 2
Ethernet 0 section.
Setting up RADIUS Authentication
If you are using a RADIUS server for user authentication, you must set
up the IntraPort to communicate with a RADIUS server and also set
some special parameters in the RADIUS server itself
Setting the IntraPort for a RADIUS Server
Just a few basic settings are required for the IntraPort to communicate
with a RADIUS server.
• Primary server IP address
• Secret
• VPN password attribute number
• VPN group attribute number
CV: Use the RADIUS Configuration dialog box. Select Global in the
dialog box, then select RADIUS Configuration.
TB: Use the configure command and set the PrimAddress, Secret,
VPNPassword and VPNGroupInfo keywords in the RADIUS
section.