Heli-Max HMXE0847 - Manual (Page 8)

8
®
TRANSMITTER SETUP TRANSMITTER SETUP
1. Install 4 AA batteries in the transmitter
by removing the battery cover from the
back of the transmitter. Double-check
the polarity of each battery before
replacing the battery cover.
2. Turn the transmitter on and lay it
down. Make sure that the blue light
behind the Heli-Max panel is lit. The
LCD screen should be on, with a
throttle position indicator and other
information.
3. Make sure the electronic trim
indicators on the display are centered.
NOTE: The transmitter must remain
still when first turned on to allow it to
calibrate.
®
FLYING YOUR 230Si QUADCOPTER FLYING YOUR 230Si QUADCOPTER
Electric motors are very dangerous. Do not work on the model
while the flight battery is plugged in as interference may cause
the main rotor blades to spin, possibly causing injury.
1. Turn on the TX465 transmitter and lay
it down near the quadcopter on a level
surface. When the display shows 000,
connect the battery but do not move
the quadcopter. When the Status LED
is steady, the 230Si can be picked up.