Heli-Max HMXE04 v1.1 - Manual (Page 5)

5
Install Batteries in the Transmitter
❏
Remove the battery cover from the back of the
transmitter. Remove the battery box and install eight “AA”
batteries in the transmitter. Double-check the polarity of
each battery before replacing the battery cover.
❏
Turn on the transmitter using the power switch as shown
above. Check the LEDs on the front of the transmitter. Only
the Green LED should be on. If the Red LED is on, then the
batteries need replacing.
Install the Transmitter Antenna
❏
Insert the antenna into the top of the transmitter and turn
clockwise until tight.
Charging the Flight Battery
❏
WARNING! The charger supplied with the AXE Mini EP
RTF is only meant to charge the supplied NiMH battery
pack. Do not attempt to charge any other type of battery with
this charger.
❏
Plug the battery charger into an AC outlet. The light on
the charger should be Green. Now plug the battery pack into
the charger. The light should turn Red, which indicates
charging. Once the battery is completely charged the light
will turn Green again, indicating it is done.
If your flight battery is completely discharged it will take
approximately one hour to re-charge.
❏
The optional ElectriFly ™ 11.1V 910mAh 15C balance
BP910 Lithium-Polymer battery (GPMP0709) can be used
for longer flight times and increased power. You must
purchase a special charger for Lithium-Polymer batteries
such as the Great Planes Lithium-Polymer Charger
(GPMM3110). To use this battery you will need to purchase
a Deans Ultra to Micro Deans adapter (GPMM3127).
ASSEMBLY INSTRUCTIONS