Heli-Max HMXG8016 - Manual (Page 2)

INTRODUCTION INTRODUCTION
Thank you for purchasing the Novus Brushless Conversion. The brushless
motor will provide greater power and longer fl ight times in comparison to the
stock brushed motor.
INSTALLATION INSTALLATION
❏
Disconnect the servos, tail motor and main drive motor from the E-Board.
Remove the E-Board and main drive motor from the mechanics. Install the
brushless main drive motor with the wire harness facing as shown above.
Ensure that the gear mesh is set correctly. Once the gear mesh has been set
correctly there should be a minimal amount of play between the gears. If you
are not comfortable setting the gear mesh by feel then place a thin piece of
notebook paper between the pinion and spur gear to set the mesh. Once the
motor screws have been tightened, remove the paper and turn the gear to verify
that it rotates freely.